HOME > Wintriss Safety Controls > WPC 2000 > Option 2 Expansion Board
WPC 2000 - Option 2 Expansion Board
Expansion Module For WPC 2000 Integrated With SmartPAC 2.
WPC 2000 Option 2 Expansion Board
The Option 2 Expansion Module for the WPC 2000/SmartPAC 2 provides additional press control functions for a
reasonable cost. Features include:
- 20 additional user-defined inputs
- 4 additional pairs of user-defined cross-checked inputs
- Hydraulic overload control
- Flywheel brake control
- Motor current readout (if equipped with an optional sensor)
- Lube system control optional
- Speed control optional
Additional User-Defined Inputs
The Option 2 Expansion Module features 20 user-configurable inputs (in addition to the 7 already present in the
WPC 2000) that can be used to monitor ancillary press functions. In addition, the Option 2 provides 4 pairs
of cross-checked inputs (in addition to the 2 already present in the WPC 2000) for monitoring safety applications.
Hydraulic Overload Control
Developed for presses equipped with an hydraulic overload system, this standard Option 2 feature emergency-stops the
press when a hydraulic overload occurs and provides the logic necessary to reset the system.
Flywheel Brake Control
On presses equipped with a flywheel brake, Option 2 can monitor a pressure or limit switch to ensure that the
flywheel brake is released or engaged at the proper time. If the optional Speed Control (see below) is used,
the flywheel brake can be pulsed for a specific amount of time.
Flywheel Brake Control Setup
Motor Current Readout
When wired to an optional current sensor, Option 2 provides a numeric high-and-low-value readout for motor
current (% load) during a stroke. This information is useful for manual counterbalance pressure adjustments.
Motor Current Display
Controls the speed of variable speed presses equipped with either eddy current or frequency drives.
Precise speeds for each mode (Inch, Single-stroke and Continuous) are conveniently entered and stored in the
SmartPAC 2ís memory for each tool. Press speed changes automatically when you change the mode, eliminating
the need for speed pots and meters on the press console.
Speed Control Setup Screen
You can control, program, and monitor a lube system that is designed to dispense an initial coating of
lubricant to press components (for example, the counterbalance cylinders) that require a controlled amount of lube before the
press begins to operate.
In addition, the Option 2 board can monitor up to two additional lube systems - such as those for
main bearings, gibs, etc - that should operate continuously once a selected device (such as the main motor) is actuated.
Lube Control Setup Screen