HOME > Wintriss Automation Controls > SmartPAC 2 > WaveFormPAC

SmartPAC 2 - WaveFormPAC Tonnage Signature Monitor

---

WaveFormPAC monitors the tonnage waveform profiles during each press stroke and stops the press if variations exceed preset limits.

• Verify setups
• Check tool timing
• Monitor snap-through (reverse) load
• Diagnose tooling problems
• Separately monitor clamping and forming forces
• Verify part quality
• Analyze draw speed
• For press speeds up to 250 strokes per minute

For the ultimate in on-the-spot setup verification, the WaveFormPAC allows you to store a benchmark waveform for each die, and compare it to the current signature right on the SmartPAC 2's screen!

To ensure that you're not exceeding the off-bottom load capabilities of your press, the WaveFormPAC allows you to do an on-screen comparison of your actual tonnage signature against the maximum tonnage curve for the press.